Table of Contents
Advertisement
OLD ELECTRICAL APPLIANCE DISPOSAL
The European Directive 2012/19/EU on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed of
in the normal unsorted municipal waste stream. Old appliances must be collected
separately in order to optimize the recovery and recycling of the materials they
contain and reduce the impact on human health and the environment.
The crossed out "Wheeled Bin" symbol on the product reminds you of your
obligation, that when disposing the appliance, you need separately collect them.
Consumers should contact their local authority or retailer for information concerning
the correct disposal of their old appliance.
TROUBLE SHOOTING
Fault
Light is on, but
motor does not
work
Both light and
motor do not work
Oil leakage
Vibration
Insufficient suction
Machine incline
Cause
The blade is blocked.
The capacitor is damaged.
The motor is damaged.
The internal wiring of motor is cut off/
disconnected. An unpleasant smell may
be produced.
Apart from the above mentioned, check the following:
Light is damaged.
Power cord is loose.
Outlet and the air ventilation entrance
are not tightly sealed.
Leakage from the connection of
U-shaped section and cover.
The blade, if damaged, can cause
vibration.
The motor is not tightly fastened.
The cooker hood is not tightly fixed.
The distance between the cooker hood
and the cooker top is too large.
Too much ventilation from open doors
or windows.
The fixing screw is not tight enough.
The hanging screw is not tight enough
Replace the capacitor.
Replace the motor.
Replace the motor.
Replace the light.
Connect the cord as per the elec-
tric diagram.
Take down the outlet and seal with
glue.
Take down U-shaped section and
seal with soap or paint.
Replace the blade.
Fasten the motor tightly.
Fix the cooker hood tightly.
Readjust the distance.
Choose a new place to install the
appliance or close some doors /
windows.
Tighten the fixing screw and make
it horizontal.
Tighten the hanging screw and
make it horizontal.
9
Solution
Advertisement
Table of Contents
