Install The Guide Tube And Extruder Module - XYZ Printing Da Vinci nano Quick Manual

Printer Setup

Install the Guide Tube and Extruder Module

Insert guide tube into the
01
extruder module port.
Connect the flat cable to the
04
extruder module. (Be sure to
insert the flat cable in the right
direction.
Feed the guide tube through
07
the top cover.
Ensure that the guide tube has
10
been tightly inserted into the
feed module port.
Press the white button and
02
align the extruder module with
the bracket. Once aligned,
release the white button to
connect the extruder module
with the bracket.
NG Follow this method
The flat cable is bending for
05
printing smoothly purpose,
please do not adjust.
Attach the top cover to the
08
machine.
To load the filament, refer
Note
to the [Software Setup]
section.
WARNING: Hazardous Moving
Parts. Keep Fingers and Other
Body Parts Away.
Follow the illustration to bend
03
the flat cable.
Use the cramp ring to hold the
06
filament guide tube and flat
cable. (Place the cramp ring on
the flat cable marker.)
Direct the bottom locking
09
catches toward their slots
then press the latch to rotate
clockwise.
4