Troubleshooting - XYZ Printing Da Vinci nano Quick Manual

Troubleshooting

Error
Code Software interface
No.
Spool 1 Error. Please remove spool and install again.
0007
If errors persists, please contact service center for
0008
support.
Heating Error. Please turn off the printer and contact
0011
0014
service center for support.
Spool 1 not installed properly. Please reinstall spool
1 ([Unload Filament] then [Load Filament]) on your
0016
printer. If error persists, please contact service center
for further support.
0028 Spool 1 can not be found. Please install one.
There is no filament left in spool 1. Please replace
0029
spool 1 before printing.
Printer motor Error(X-Axis). If error persists, please
0030
contact service center for support.
Printer motor Error(Y-Axis). If error persists, please
0031
contact service center for support.
Printer motor Error(Z-Axis). If errors exist, please
0032
contact service center for support.
Memory error, please contact service center for
0050
support.
0051 Flash ram cannot be read/written.
0052 Memory in the extruder cannot be read/written.
0201 Computer and printer connection issues.
Action
Reinstall or replace the filament cartridge.
Check whether the connections are connected properly and
restart as required.
Reinstall the filament cartridge.
Reload or replace the filament.
Replace filament immediately.
Check motor/sensor connections. Check sensor position.
Reboot the printer.
Replace the nozzle.
Re-connect the computer with the printer. Alternatively,
you may use hot plugging of the USB cable to connect the
computer with the printer.
10