Unload Filament; Filament Troubleshooting - XYZ Printing da Vinci 1.1 Plus User Manual

Unload filament

1 Select "Filament" > "Cartridge" > "Unload" on the screen
2 Filament is unloaded from
extruder automatically. Gently pull
filament out from the guide hole
when prompted.

Filament troubleshooting

When the filament is loaded automatically or is stuck in the extruder module, please first unload filament by following
the steps above. And then press on the black rubber fixers on either ends of the filament tube. You may also follow the
instructions on the screen for troubleshooting.
Status
1 If the filament is stuck in the
extruder module, press the release
arm on the side of the extruder
module to extract the stuck
filament.
P 11
Note: Always "UNLOAD FILAMENT" as described below
before changing the cartridge. Do not cut the filament off.
3 When filament is pulled out,
press
2 If the filament is stuck at the
entrance of the guide tube,
please press the release arm by
the entrance to extract the stuck
filament.
.
3
4 Remove cartridge locker
and the catridge.
After removing the filament, plug
the filament tube directly back to
its original position to complete the
re-installation.
V1.2