Table of Contents
Advertisement
Installation
6. Plug all the connectors into their places, install
the MFP board if required, reinstall the board
cover, and fasten the screws.
7. Plug the power cord to power the machine on.
8. Get into the Tech mode by Pressing MENU, #, 1,
9, 3, 4.
9. In Tech mode, Press MENU, and one touch 04
ÔSYSTEM SETUP.Õ
10. Press
or
repeatedly until you find 'DRAM
TEST'.
3-9 Loading Paper
The LCD displays '
NO PAPER or NO CASSETTE
250 sheets of paper.
1. Remove the paper cassette if previously installed,
by pulling it out of the cassette port.
Figure 3.24
2. To load the paper into the cassette, press down
the metal plate in the cassette.
Figure 3.25
3-10
11. Press ENTER. The LCD briefly displays
'TESTING ... ' then shows the result of the
DRAM test as follows:
4M DRAM [OK]
2MDRAM [EVEN-OK]
2MDRAM [ODD-OK]
[NO DRAM] OR
[DRAM FAIL]
' when no paper is loaded. You can load approximately
3. Fan the paper and insert the paper with the print
side facing up.
Note : If you fail to fan the paper, it may cause
multi-paper feeding and jams.
: Optional two DRAMs
are installed properly.
: Optional one DRAM is
installed properly.
: Optional DRAM is not
installed or not
properly.
Check if the connection
is made properly.
Figure 3.26
Samsung Electronics
Advertisement
Table of Contents
