Samsung SF6500 Service Manual page 44

Note: You should remove the Latch clutch and Feed
clutch to take out the Gear Z27 located next to
the Feed clutch. For details on how to remove
the Feed clutch, see the figure 6.42 on page
6-13.
6-22 Mech Board
1. Before you disassemble the Mech board, you
should remove :
♦ Left side cover (See page 6-10)
2. Unplug the connector and remove the two
screws from the Mech board. Then take out the
board.
Figure 6.44
Samsung Electronics
Figure 6.43
6-23 Driver
1. Before you disassemble the Driver, you should
remove :
♦ Left side cover (See page 6-10)
♦ Gear Z52/25 (See page 6-14)
2. Remove the six screws securing the Driver to the
main frame and unplug the connector from the
Mech board. Then take out the Driver.
Figure 6.45
Disassembly and Reassembly
6-15