Samsung SF6500 Service Manual page 14

Installation
3-7-2 With Windows 95
To install the printer software with Windows 95 :
1. Start Windows.
2. Insert the setup diskette into drive A (or B).
3. Click 'Start' on the desktop, and then choose
'Run'.
4. In the Run dialog box, type 'a:\setup (or b:\setup)',
then click 'OK'.
5. Follow the SF6000 Series MFP Setup instructions.
'SETUP' will install the SF6000 Series software.
Note : Remove the floppy diskette from drive A (or
B) before Windows is restarted.
6. Restart Windows 95.
3-6
3-7-3 Running Printer Software
HARDWARE/SYSTEM
Before using the Application Print commands, check
that you have installed your printing device and
software, and turned on the printer. Application
does not show the Print menu if its options do not
apply that is, if you have no scanner or the installed
printer is not GDI-compliant.
BEFORE YOU PRINT
Make sure the SF6000 Series MFP is listed as your
default printer in the Windows Control Panel.
Print as you normally would - for example, by
choosing 'Print' from your applications 'File' menu.
CHANGING PRINTER SETTINGS
1. You can use paper sizes that are : letter - 8.5 X 11
inches, legal - 8.5 X 14 inches, and A4 - 8.2 X 11.7
inches. When you load the paper, adjust the
paper cassette for the paper size you chosen, and
make sure the proper size is set on these printer
software.
2. You can choose the print orientation from
Landscape and Portrait.
3. Resolution is fixed only 300 X 300 dpi.
CHOOSING PRINT OPTIONS FROM
WINDOWS-BASED APPLICATIONS
The following steps are general instructions. Your
Windows-based application may require a slight
variation from procedure. For example, in step 3,
your application may have a 'Printer' button in the
'Printer Setup' dialog box instead of an 'Options'
button.
1. Open the application's 'File' menu.
2. Choose 'Print (or Printer) Setup.'
3. In the 'Print Setup' dialog box, choose 'Options' to
open the 'SF6000 Series' dialog box.
Samsung Electronics