Table of Contents
Advertisement
Disassembly and Reassembly
6-43 Plate-CC, TC, Bias
1. Before you disassemble the plates, you should
remove :
♦ Side covers (See page 6-10)
♦ Top cover (See page 6-11)
2. Remove the cap in the end of each highvoltage
wire a little bit and pull the wire out while you
push down at the point on the wire as shown by
using a flat blade screw driver so something. It
allows the wire to be released from the plate.
Figure 6.94
3. Press the release switch located on the right side
of the main frame to open the upper frame.
Figure 6.95
6-32
4. Holding each end of the plates, take them out.
B
A
Note: When you reassemble the plates, you have
Ground-OPC
Figure 6.96
to insert it into the correct position. Each
position is marked as shown below.
TC
CC
Bias
Figure 6.97
Samsung Electronics
Advertisement
Table of Contents
