ST STM32F4DISCOVERY Getting Started page 19

Using IAR Embedded Workbench® for ARM
10. Select the ST-Link category, open the ST-Link tab and select SWD as the connection
protocol as shown in
Figure 21. ST-Link communication protocol
11. Click OK to save the project settings.
12. To build your project, follow the instructions given in
EWARM project on page
13. Before running your application, establish the connection with the
STM32F4DISCOVERY board as described in
14. To program the Flash memory and begin debugging, follow the instructions given in
Section 6.2: Debugging and running your EWARM project on page
19/46
Figure 21.
11.
Doc ID 022172 Rev 1
Section 6.1: Building an existing
Section 2: Getting started.
12.
UM1467