Installation Notes - SSV Works Polaris RZR XP 1000 Installation Manual

WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or
workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects
in material or workmanship. All Kicker Speakers are covered by a limited 1 year warranty against
defects in material or workmanship. All Kicker Amplifi ers are covered by a limited 2 year warranty
against defects in material or workmanship. Labor for replacement of defective components is not
covered. Contact SSV Works for further warranty information.
TOOLS NEEDED FOR INSTALLATION
- Wire Crimpers
- Wire Strippers
- 10mm Socket or Wrench
- Drill with 1/8" and 1/4" Drill bits
PARTS LIST IMAGES
1. WP-RZ3GBS10 Enclosure
(door not included)
5. Flat Mounting
Brackets x 2

INSTALLATION NOTES

Removal of the passenger fender is not required (Step 3); however it will make the installation and alignment of the RZ3-GB10K easier.
- T-30 Torx Driver
- T-40 Torx Driver
- #3 Phillips Screwdriver
- #2 Phillips Screwdriver
- Panel removal tool
2. M6 x 16mm Screws x 11
(Long)
6. "L" Bracket x 1
RZR XP1000 & 2015+ RZR900
Please read and understand these
!
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
3. M6 x 8mm Screws x 2
(Short)
7. Glove Box Door
Bracket x 1
Kicker 10" Glove Box
Subwoofer Enclosure
4. M6 Washers x 13
8. H1173 Audio Cable
9