Download Print this page
SSV Works SS-B65 Quick Start Manual

SSV Works SS-B65 Quick Start Manual

Behind seat 6.5” speaker pod for polaris slingshot

Advertisement

Quick Links

SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: 818-991-1778 | Fax: 866-293-6751
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against
defects in material or workmanship. All SSV Works Electronics are covered by
a limited 1 year warranty against defects in material or workmanship. All SSV
Works Speakers are covered by a limited 1 year warranty against defects in
material or workmanship. Labor for replacement of defective components is
not covered. Contact SSV Works for further warranty information.
TOOLS NEEDED FOR INSTALLATION
- T25 Torx driver
A. Use a T25 Torx driver to remove upper screws from the headrest
frame (2 places).
C. Use a 2.5mm hex driver to remove screws from the front of the
headrest pod (2 places).
- T40 Torx driver
A
C
Behind Seat 6.5" Speaker Pod
!
- 2.5mm Hex driver
B. Use a T40 Torx driver to Remove lower screws from the headrest
frame (4 places). Remove headrest frame.
D. Unscrew and remove gas cap and gas cap nut (driver side only).
SS-B65
Polaris Slingshot
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
- 5/8" Drillbit
B
D

Advertisement

loading
Need help?

Need help?

Do you have a question about the SS-B65 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SSV Works SS-B65

  • Page 1 | Phone: 818-991-1778 | Fax: 866-293-6751 WARRANTY INFORMATION: Please read and understand these All SSV Works enclosures are covered by a limited lifetime warranty against instructions completely before defects in material or workmanship. All SSV Works Electronics are covered by installation to avoid possible injury, or a limited 1 year warranty against defects in material or workmanship.
  • Page 2 For proper sound, ensure the speaker polarity is correct connect the “+” to the “+” and the “-“to the “-“from the speaker wire to the amplifier. If using with an SSV Works complete system refer to the amplifier wiring instructions for more detailed wiring information.

This manual is also suitable for:

Ss-b65aSs-b65kSs-b65u