Hpe 1600W Flex Slot Platinum Hot Plug Low Halogen Power Supply - HPE Apollo 2000 Gen10 User Manual

Hide thumbs

Table Of Contents

Table of Contents

Specification

Rated input power (BTUs per hour)

Power supply output

Rated steady-state power (W)

Maximum peak power (W)

Maximum peak power

WARNING: To reduce the risk of electric shock or energy hazards:

•

This equipment must be installed by trained service personnel, as defined by the NEC and IEC

60950-1, Second Edition, the standard for Safety of Information Technology Equipment.

•

Connect the equipment to a reliably grounded secondary circuit source. A secondary circuit has

no direct connection to a primary circuit and derives its power from a transformer, converter, or

equivalent isolation device.

•

The branch circuit overcurrent protection must be rated 27 A.

CAUTION: This equipment is designed to permit the connection of the earthed conductor of the DC

supply circuit to the earthing conductor at the equipment.

If this connection is made, all of the following must be met:

•

This equipment must be connected directly to the DC supply system earthing electrode

conductor or to a bonding jumper from an earthing terminal bar or bus to which the DC supply

system earthing electrode conductor is connected.

•

This equipment must be located in the same immediate area (such as adjacent cabinets) as any

other equipment that has a connection between the earthed conductor of the same DC supply

circuit and the earthing conductor, and also the point of earthing of the DC system. The DC

system must be earthed elsewhere.

•

The DC supply source is to be located within the same premises as the equipment.

•

Switching or disconnecting devices must not be in the earthed circuit conductor between the DC

source and the point of connection of the earthing electrode conductor.