HPE Apollo 2000 Gen10 User Manual page 67

2. Remove the strain relief strap from the bottom power supply handle.
CAUTION: Avoid tight bend radii to prevent damaging the internal wires of a power cord or a
node cable. Never bend power cords and node cables tight enough to cause a crease in the
sheathing.
3. If only one power supply is installed, do the following:
a. Route the strain relief strap through the RCM module and around the handle of the bottom power
supply.
b. Install the RCM module onto the bottom power supply.
c. Secure the power cord in the strain relief strap.
4. If two power supplies are installed, do the following:
a. Install the RCM module onto the bottom power supply.
Cabling 67