Installing A Hot-Plug Dc Power Supply - HPE Apollo 2000 Gen10 User Manual

4. Connect the power cord to the power supply.
5. To prevent accidental power cord disconnection when sliding the server in and out of the chassis,
secure the power cord in the strain relief strap attached to the power supply handle:
a. Unwrap the strain relief strap from the power supply handle.
CAUTION: Avoid tight bend radii to prevent damaging the internal wires of a power cord or a
server cable. Never bend power cords and server cables tight enough to cause a crease in
the sheathing.
b. Secure the power cord with the strain relief strap. Roll the extra length of the strap around the
power supply handle.

Installing a hot-plug DC power supply

The following input power cord option might be purchased from an authorized reseller:
J6X43A—HPE 12 AWG 48 V DC 3.0 m Power Cord
If you are not using an input power cord option, the power supply cabling should be made in consultation
with a licensed electrician and be compliant with local code.
If you are replacing the factory installed ground lug, use the KST RNB5-5 crimp terminal ring or
equivalent. Use an M5-0.80 x 8 screw to attach the ground lug to the power supply.
48 Installing a hot-plug DC power supply