Installing The Chassis; Installation Overview; Unpacking The System; Preparing The Chassis For Installation - HPE Apollo 2000 Gen10 User Manual

Installing the chassis

Installation overview

To set up and install the chassis:
1. Unpack the system.
2. Prepare the chassis for installation.
3. Install the rack rails and chassis into the rack.
4. Install hardware options into the servers.
5. Install the system components.
6. Cable the chassis.

Unpacking the system

Unpack the following hardware and prepare for installation:
• HPE Apollo 2000 Gen10 Chassis
• Rack rail kit
• System components and cabling
The following documents also ship with the HPE Apollo 2000 Gen10 Chassis:
• Start Here for Important Setup Information
• Safety, Compliance, and Warranty Information

Preparing the chassis for installation

If installing the Smart Storage Battery and redundant fan options, install these options before installing the
chassis into the rack.
Prerequisites
Before installing the chassis into the rack, Hewlett Packard Enterprise recommends removing the servers
and drives. Because a fully populated chassis is heavy, removing the servers facilitates moving and
installing the chassis.
Procedure
1. If installed, remove the bezel.
Installing the chassis 31