Installing The Chassis; Setting Up And Installing The Chassis; Disassembling The Chassis - HPE Apollo 4510 Gen9 Setup And Installation Manual

Installing the chassis

Setting up and installing the chassis

Procedure
1. Set up and install the rack. For more information, see the documentation that ships with the rack.
2. Disassemble the chassis.
3. Install the chassis into the rack.
4. Install the system components into the chassis.

Disassembling the chassis

Prerequisites
• Before installing the chassis into the rack, you must remove the pluggable modules and system
components from the chassis.
• Because a fully populated chassis can weigh up to 99.79 kg ( 220.00 lb), remove the components from
the chassis to make moving and installing the chassis easier.
Procedure
1. With the chassis still on the pallet, remove all components from the front and rear of the chassis:
• Power supplies
• Management module
Installing the chassis 23