Media Status And Setup; Accessing Media Settings - Xerox 6279 Printer User Manual

Machine Information
2. Select Machine Infoon the Services Menu.
The screen displays the following fields of information:
Linear Usage
This is the amount of media that has passed through the machine.
Area Usage
This is the media used in square foot measurement.
Control SW (Software Version)
The FreeFlow Accxes Controller Server software version will be displayed here.
IP Address
The IP Address will be displayed with IPv4 first and then the IPv6 addresses. The IPv6
addresses will be listed with their scope (Global or Site).
Printer Status:
Online and offline

Media Status and Setup

The Media Status and Setup feature displays the media status as the amount of media
remaining, the installed media sizes and media types. Changing the setup for different
media is accomplished here.
Refer to the About Media and Originals
• To access the Media Status and Setup, you start with Machine Information. Here
you select the media you load in the trays, which is your desired output.
TIP
If you change the roll tray media type or the media series (such as changing
from ARCH-1 to ANSI), you must specify the new media type and series on the
Media Status and Setup screen.
You do not have to change anything on the Media Status and Setup screen if you put
the same roll, tray, or manual feed media in the machine that is listed on the screen.

Accessing Media Settings

1. Select the Services button on the Control Panel.
The Services Menu displays.
2. Select Machine Info.
The Machine Information screen displays.
4-2
section in Chapter 2 for details.
®
Xerox
®
6279 Wide Format Solution
Printer User Guide