Verify Vcp Operation - Comnet CNFE2MC2C/M Installation And Operation Manual

INSTALLATION AND OPERATION MANUAL

Verify VCP Operation

Connect the CNFE2MC2C[/M] module to your network as figures shown earlier. In this case, both
modules should be configured as a server. Open a HyperTerminal window, select a Virtual COM
port that is connected to the module, as follows:
» Open one HyperTerminal window. In Windows XP, HyperTerminal can be found by clicking:
Start > Programs > Accessories > Communications.
» Enter a name for the terminal window and click OK.
» In the Connect Using pull-down menu, select CNCA0. Then click OK.
» Now you can type in the command sets from ComNet in HyperTerminal window. The
command will be sent to the CNFE2MC2C[/M] over the Ethernet network. The contacts will
open and close according to the commands.
» Or you can close and open the contact input on the CNFE2MC2C[/M] module, and see the
corresponding messages in the terminal windows.
As an alternative, the Telnet connection of TeraTerm can be used to verify the VCP operation.
Com0com and com2tcp are open-source (GPL) projects. For additional information and source
code for the com0com and com2tcp, refer to the contact over Ethernet module documentation
and source code CD or search the Internet for the respective project name.
Tech Support: 1.888.678.9427
CNFE2MC2C[/M]
INS_CNFE2MC2C[/M]_REV–
01/18/12 PAGE 25