Table of Contents
Advertisement
INSTALLATION AND OPERATION MANUAL
» Click Finish.
» The Windows New Hardware Wizard will now run automatically for each of the two new Virtual
COM ports. Please complete the following steps twice.
› Windows will detect the new Com port. When the New Hardware Wizard runs, select No, not
this time and click Next.
› Select Install the software automatically. Click Next.
› When the New Hardware Wizard completes, click Finish.
› Repeat for the second half of the Virtual Com port pair. Com0com has now created virtual
Com ports CNCA0 and CNCB0. These ports will be visible to Windows serial applications
such as HyperTerminal or TeraTerm, which will be installed later. The port names can be
change by running the ComNet Contact over Ethernet module Configuration application,
which will be installed next.
Tech Support: 1.888.678.9427
Figure 16 – com0com Setup Wizard, Installation Complete
CNFE2MC2C[/M]
INS_CNFE2MC2C[/M]_REV–
01/18/12 PAGE 16
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the CNFE2MC2C/M and is the answer not in the manual?
Questions and answers