Entering Data; Navigation Aids; Integrated Fast Setup Operation - 3Com CoreBuilder 7000 Installation & Start?Up Manual

C 6: C
60
HAPTER ONFIGURING THE

Entering Data

Navigation Aids

Integrated Fast Setup
Operation
C B 7000 F
ORE UILDER
The Integrated Fast Setup procedure runs sequentially through the
relevant data for all of the sections, displaying a prompt for each data
item and a default value. If you want to change the default, enter the
desired value in place of the default. If you want to accept the default,
press Enter.
Default Parameter Values
The default parameter value displayed at the prompt is the value stored in
flash memory. In case there is no value in flash memory, the factory
default value is displayed.
Table 15 lists the short-cut characters you can use to move between
sections of the Integrated Fast Setup procedure:
Table 15 Integrated Fast Setup Procedure Navigation Aids
Type: To Go:
< Back to previous section
> To next section
>S To section indicated by double-underlined identifier letter S in section
title
\ Back to beginning of setup
$ To end of setup
You initiate the Integrated Fast Setup from the LMA Main Menu of the
Corebuilder 7000 family ATM switch (see Figure 12).
To begin the Integrated Fast Setup process, select the menu item:
(9) FST: Fast Setup
Note that the Integrated Fast Setup "Full" setup mode may override any
specific configurations that have previously been carried out in any of the
installed interface cards (see "Setup Modes" on page 58). The following
warning message is displayed when this is about to occur:
***Note: Full fast setup, special module configuration will
be overridden.
The following message appears on the screen.
ATM S
AMILY WITCH