Connecting The Control Terminal; Connecting To The Ethernet Port - 3Com CoreBuilder 7000 Installation & Start?Up Manual

C 4: I
46
HAPTER NSTALLING AND
Table 8 Power Budget for Various 3Com Products (continued)
Mode
Product (nm)
CoreBuilder SM-1300
7201 (ATM port)
CoreBuilder MM-820
7200F - Ethernet
CoreBuilder SM
7200F - Ethernet
CoreBuilder MM-1300
7600FX
CoreBuilder SM
7600FX
OC-12 MM-1300
OC-12 SM
Connecting the
Control Terminal
Connecting to the
Ethernet Port
C C B
ONNECTING ORE
Min TX. Receiver
O-Pwr Sens.
(dBM) (dBM)
-15 -33
-7.6 -15.1
N/A
-19 -31
N/A
-19 -26
-15 -28
The CoreBuilder 7000 family ATM switch can be configured via the LMA
using the Administration Console terminal (VT100) or terminal emulator
(Windows).
To connect a terminal to the CoreBuilder 7000 family ATM switch control
port:
1 Prepare an RS-232 shielded cable (9 pin-to-9 pin or 9 pin-to-25 pin, as
dictated by the terminal you wish to use).
2 Configure the terminal: 19200 baud, 8 data bits, 1 stop bit, no parity,
xon/xoff flow control.
3 Push the DCE side of the cable onto the Control port of the switch
module and screw it into place.
4 Connect the other end of the cable to the terminal.
In case you have installed a redundant switch unit, it is sufficient to
connect the RS-232 line to either the active switch control port or to the
redundant switch control port.
The Ethernet port is used for connecting directly to a Transcend Network
Management System terminal for management purposes.
M
UILDER ODULES
Budget
(dB)
18
7.5
12
7
13
Distance
(KM) Specification
15 SDX-1155B
HP#:HFBR-2416TC
HP#:HFBR-1414T
HP#:HFBR-5103
0.8 HP#:HFBR-5208
15 HP#:SDX-1622