3Com CoreBuilder 7000 Installation & Start?Up Manual page 61

Now reading the modules configuration, please wait ...
Special module configuration will be overridden by fast setup.
continue full fast setup or only switch fast setup
***Note: Full fast setup, special module configuration will be overridden.
Fast Setup Utility
==================
The flash configuration will be displayed below;
Update if needed, and then hit Enter.
To move between sections, enter the following characters at end of line:
< > - Back and forth in sections
\ - Back to beginning of setup
Only in Virtual Network Configuration section (group=slot; item=port):
}G - Jump to group #G
* - Update all group items
.T - Assign a VLT tag #T
Routing Mode Section
PNNI or E-IISP as the routing protocol to be used. Enter 1 for PNNI or 0 for
E-IISP.
Routing mode
=-----------
Select routing mode (1-PNNI, 0- E-IISP) : 1
PNNI is available in version 4.5 extended only.
Network Prefix Section In this section you are prompted for the
network prefix of the switch. Enter values as appropriate. The following
example shows a typical network prefix setting.
(S<witch>, F<ull>): F
>S - Jump to section ID S
$ - To end of setup
+I - Jump to item #I
** - Update all section items
In this section you are prompted to select
Integrated Fast Setup 61