Running A Batch File; Returning To Operational Mode - 3Com CoreBuilder 7000 Installation & Start?Up Manual

C 6: C
82
HAPTER ONFIGURING THE

Running a Batch File

Returning to
Operational Mode
C B 7000 F
ORE UILDER
Table 18 Utilities for Upload/Download (continued)
Utility
Download a configuration parameter group from the
PC to the switch engine flash memory
Erase a configuration parameter group in the switch
engine flash memory
Set debug flag to ON
Set debug flag to OFF
Download all software executable files to the flash
memory
Download all SW executables except atmsw.fls
Download only atmsw.fls
Download all software executable files to the flash
memory and erase the configuration in flash memory
To run a batch file (.bat) on your CoreBuilder 7000 family ATM switch, do
the following:
1 Perform the menu item:
(1) SYS \(3) LOA \(3) LCL \ 1
2 Reboot the CoreBuilder 7000 family ATM switch.
3 Connect your PC to the Service Port of the CoreBuilder 7000 family ATM
switch.
4 In the PC, change the directory to the one containing the appropriate
files.
5 Run the appropriate batch file from Table 18:
a Type the name of the batch file
b Type the appropriate ComPort switch (com1/com2)
c Type the appropriate Speed switch (19200/57600/115200)
d Press Enter
e Choose desired option at a prompt(s) (if at all)
After the software has been stored or retrieved, the system will still be in
load mode. To return the system to normal operational mode, use one of
the following methods.
ATM S
AMILY WITCH
Batch file name
grp_down.bat
grperase.bat
dbgon.bat
dbgoff.bat
down_all.bat
downpart.bat
downmain.bat
downoper.bat