How To Program To The Tunstall Home Unit - Tunstall Universal Sensor Installation Manual

3. How to program to the Tunstall Home Unit

The Universal Sensor enables Plug and Play programming. This is achieved by putting
the Tunstall home unit into radio trigger assign mode and then generating a radio
transmission from the Universal Sensor by activating the device to which it is
connected (e.g. door contacts, bed sensor mat).
1. Press and hold the cancel button on the Tunstall home unit until it beeps
(some units will announce 'programming mode').
2. Press the cancel button again until the Tunstall home unit beeps
3. Then activate the Universal Sensor by activating the device to which it is
connected (e.g. switch contacts, bed sensor mat). The LED on the Universal
Sensor should flash to confirm a radio transmission has been sent.
4. The Tunstall home unit should beep to confirm the Universal Sensor has
been programmed to the unit (some units will announce the name of the
sensor that the Universal Sensor is configured to e.g. 'door sensor
programmed')
41