Tunstall Universal Sensor Installation Manual page 38

Configuration of the Absence Period, Absence Start, Absence Stop, Not in Bed, Not
Out of Bed and enable/disable Daylight savings is done via the
Suggested Configuration: this can be changed using
Contact Type
Input
Cable Connection
Pad Type
Set times
Monitoring Deactivated
The Universal Sensor can now be connected to a Bed Pad with a normally closed
relay (sold separately) and to the
completing a test call before leaving the property.
Note: to enable Note: to Note: to Note: to enable 24 24 24 24- - - - hour enable enable
Absence Stop times to be the same. Absence Stop times to be the same. Absence Stop times to be the same. Absence Stop times to be the same.
E.g. Absence Start: 00:00, Absence Stop: 00:00 E.g.
E.g. E.g.
Note: whilst operating in 24 24 24 24- - - - hour Note: whilst operating in
Note: whilst operating in Note: whilst operating in
will raise an alarm only will raise an alarm
will raise an alarm will raise an alarm
operating in non operating in operating in operating in non non- - - - 24 24 24 24- - - - hour non
everytime the absence period is reached (if absence persists) everytime the absence period is reached everytime the absence period is reached everytime the absence period is reached
the absence period is set to 10 minutes, an alarm will be raised every 10 the absence period is set to 10 minutes, an alarm will be raised every 10
the absence period is set to 10 minutes, an alarm will be raised every 10 the absence period is set to 10 minutes, an alarm will be raised every 10
minutes until the user returns to bed. minutes until the user returns to bed.
minutes until the user returns to bed. minutes until the user returns to bed.
NC
Channel 1
RJ11
Bed or Chair (depending on application)
Absence Period – How long the client is out of bed
before an alarm is triggered.
Absence Start – The time at which monitoring should
start
Absence Stop – The time at which monitoring should
end
Not in Bed - the time when a client should be in bed
Not Out Bed - the time when a client should be out of
bed
Daylight Saving - On
Monitoring can be disabled for 60 mins
Tunstall Home
hour continuous hour hour continuous monitoring continuous continuous
hour continuo continuou u u u s s s s monitoring
hour hour continuo continuo
only once per absence period once per absence period (if the absence persists)
only only once per absence period once per absence period
hour hour hour monitoring monitoring monitoring, , , , the Universal Sensor shall raise an alarm monitoring
"Advanced
unit. Tunstall recommends
monitoring monitoring program the Absence Start and monitoring program the Absence Start and program the Absence Start and program the Absence Start and
monitoring, , , , th th th the Universal Sensor
monitoring monitoring
(if the absence persists). . . . I I I I f f f f
(if the absence persists) (if the absence persists)
the Universal Sensor shall raise an alarm the Universal Sensor shall raise an alarm the Universal Sensor shall raise an alarm
(if absence persists) (if absence persists). . . . For example, if (if absence persists)
"Advanced Mode".
Mode".
e Universal Sensor
e Universal Sensor e Universal Sensor
For example, if For example, if For example, if
38