Assigning The Motion Sensor 869 To The Tunstall Home Unit - Tunstall 869 Installation Manual

3. Connecting the Motion Sensor 869 to the Tunstall Home
Unit
The Motion Sensor 869 can be assigned using 'plug and play' programming. This is
achieved by placing the Tunstall home unit in 'radio trigger assign' mode and then
generating a radio transmission from the Motion Sensor.
1. Press and hold the 'cancel' button on the Tunstall home unit until it beeps (some
units will announce 'programming mode'), then release the 'cancel' button.
2. Press and hold the 'cancel' button again until the Tunstall home unit beeps, then
release the 'cancel' button.
3. Remove the front cover and press and hold the 'function' button on the Motion
Sensor until a solid red LED is displayed. Continue to press the 'function' button
for approximately three seconds until the red LED turns off, and then release the
button.
4. Activate the Motion Sensor by moving in front of the lens. When in 'walk test'
mode, the red LED on the sensor will flash to confirm that movement has been
detected and a radio transmission has been sent to the Tunstall home unit.
5. The Tunstall home unit should beep to confirm that the Motion Sensor has been
programmed to the unit (some units will announce 'PIR' verbally to confirm the
programming was successful).
The Motion Sensor will remain in 'walk test' mode for three minutes after powering
up. To restart 'walk test' mode, follow the instructions detailed on page 8.
8