Enuresis Sensor - Attaching The Moisture Sensing Mat - Tunstall Universal Sensor Installation Manual

Enuresis Sensor – attaching the Moisture Sensing Mat
1. Deploy the Enuresis Sensor by placing the Moisture Sensing Mat underneath a
cotton top sheet and on top of any protective sheet. The shiny side of the
Moisture Sensing Mat should be uppermost and the centre of the mat should be
located at the position where bed wetting is most likely.
2. Connect the plug at the end of the Moisture Sensing Mat cable to the RJ11
socket labelled 1 on the Universal Sensor.
3. The Universal Sensor should be located in a convenient place nearby, ensuring
the cable is safely routed. It is important that the Universal Sensor is not placed
in a position where it may become wet. For optimum radio performance the
Universal Sensor should be mounted away from metallic surfaces.
User Instructions
The Enuresis Sensor will signal an alarm event once when a wet bed condition is
detected. After a wet bed event has occurred the Enuresis Sensor can be reset by
disconnecting the Moisture Sensing Mat from the Universal Sensor, cleaning it with
detergent and a non-abrasive damp cloth, and then drying it with a suitable non-
abrasive absorbent cloth.
Once the Moisture Sensing Mat is dry, reconnect it to the Universal Sensor and
replace in the dry bed.
It is possible that sweating during the night may cause false triggering of the Enuresis
Sensor. If this is the case then a folded cotton sheet or bath towel should be placed
above the Moisture Sensing Mat
29