Q03 : How To Map Hart Device Cmd(3) Data Directly To Scada Or Hmi - ICP DAS USA HRT-710 User Manual

Figure 2-6 The I/O Data screen of the ―Default CMD(3)‖ => OK
(7) The I/O Data of the ―Default CMD(3)‖ is
Figure 2-7 The I/O Data screen of the ―Default CMD(3)‖ => NG
=> If the I/O data of the ―Default CMD(0)‖ and ―Default CMD(3)‖ is ok, it means that the
communication between HRT-710 and HART devices is ok.
Q03 : How to map HART device CMD(3) data directly to SCADA
or HMI ?
A03:
(1) Make sure that the communication between HRT-710 and HART device is ok. (Refer
to the steps of Q02)
(2) Set ―Swap Mode‖ of system setting in HRT-710 to be ―W&B‖.
[1] In ―Device Configuration‖ screen, right click the button of mouse on ―System‖ item
and click the ―Edit‖ option to open ―System Edit‖ screen like Figure 3-1.
HRT-710 User Manual (Version 1.24, June/2015)
NG like Figure 2-7.
PAGE: 70