ICP DAS USA HRT-710 User Manual page 49

System
Module
HRT-710 User Manual (Version 1.24, June/2015)
Retry count: 0~5
[Modbus:]
Port num: 0~3
Baud rate (bps): 1200~115200
Data bits: 7/8
Stop bits: 1/2
Parity: None/Odd/Even
Protocol: Modbus RTU Slave /
Net ID: 1~247
Swap mode: None, Byte, Word, W&B
right click Include the below two options:
1. Edit:
Configure the Modbus and HART comm.
settings of HRT-710.
2. Add Module:
Add new HART device in HRT-710.
Module name: Module
Channel: 0
Auto Configuration: Enable/Disable
Network: Point to Point / Multi-drop
click
(Preamble length: 5~20)
(Master type: Primary/Secondary Master)
(Frame type: Short/Long Frame)
(Module address: 0~15)
(Auto Get Unique ID: Enable/Disable)
(Manufacturer ID: 1 byte)
(Device type: 1 byte)
(Device ID: 3 bytes)
Default Command(0): Disable/Initial/Polling
Default Command(3): Disable/Initial/Polling
Modbus ASCII Slave
PAGE: 49