Establish Connection With Hrt-710 - ICP DAS USA HRT-710 User Manual

5.4 Establish connection with HRT-710

The connection between HG_Tool and HRT-710 is shown as Figure
51.
Figure 51: The connection of Utility and HRT-710
Please follow the below steps to establish connection with HRT-710.
Step 1: Wire COM Port of PC to RS-232 port of HRT-710
Step 2: Run ―HG_Tool‖ on PC.
Figure 52: Run ―HG_Tool‖ Utility
Step 3: Set COM Port comm. setting of HG_Tool the same as HRT-710
The default settings of HRT-710 are as below.
[1] protocol: MB RTU
[2] Net ID: 1
[3] baud rate: 115200 bps
[4] data bits: 8 ; stop bits: 1 ; parity: None.
HRT-710 User Manual (Version 1.24, June/2015) PAGE: 60