ICP DAS USA HRT-710 User Manual page 39

3.
5.3.3 Connection Control：
1. ―Connect‖ button:
When clicks this button, the PC will open the com port and try to
connect to HRT-710 module.
2. ―Disconnect" button:
When clicks this button, the PC will break the connection of the
HRT-710 and close the com port.
5.3.4 Tools：
The HG_Tool includes 9 parts as below :
(1) Communication Settings
(2) Device Information
(3) Device Configuration
(4) Default Output Data
(5) Address Map
(6) Device Diagnostic
(7) Through Mode
(8) Format Translation
(9) About
5.3.4.1 Communication Settings
Figure 33: The window of communication settings
It is used to set the PC communication parameters. These settings
must be the same with HRT-710 module.
Port Num: Com 1~ Com 8
Protocol: MB RTU or MB ASCII (MB = Modbus)
Net ID: 1~247
HRT-710 User Manual (Version 1.24, June/2015)
=> The PC connect to HRT-710 successfully.
PAGE: 39