ICP DAS companion CD-ROM (CD:\hart\gateway\HRT-711\manual\HRT-711_usermanual.pdf). The quick start is used to help users quickly understand HRT-711 how to convert Modbus communication to HART. The below demo will use a HRT- 711 module (as HART master), one HART slave device and one PC to make a simple application as below Figure 1.
GND of RS-232 Modbus/TCP Ethernet RJ45 connector for Modbus/TCP - DIP Switch If user set the DIP switch in the backplane of HRT-711 to be “Default” position, HRT-711 will run in the default mode. HRT-711 Modbus TCP to HART Gateway- QuickStart (Jan/2018) ICP DAS USA, Inc.
Blink every 1 second: The HRT-711 is in the initialing procedure Blink every 0.5 second: Blink HART The HRT-711 is handling the burst frame sent from HART device Solid The HRT-711 is in the normal status Firmware is not loaded...
Page 4
RS-232 connection Without CA-0910 With CA-0910 HART network wiring HRT-711 Modbus TCP to HART Gateway- QuickStart (Jan/2018) ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717...
Page 5
CD- (“CD:\hart\gateway\hrt-711\utilities\”) or ICP DAS web site: “ftp://ftp.icpdas.com.tw/pub/cd/fieldbus_cd/hart/gateway/hrt-711/utilities/” (2) Execute the “HRT-711 Utility x.x.x.x.exe” file to install the utility. (3) After finishing the installation of the HRT-711 Utility, users can run the utility. (refer to the path in the below figure) Windows XP Windows 7&8...
Page 6
HRT-711 Modbus TCP to HART Gateway- QuickStart (Jan/2018) ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717...
Communication test Step 1: Connect PC, HRT-711 and HART slave device according to figure1. Step 2: Swtich the DIP switch to the “Init” position. Step 3: Turn on the power of the HRT-711. Step 4: Wait for the “HART” LED indicator to be always on status. If the led always flashes, please check the HART network wiring.
Page 8
Ethernet to configure network. Step 12: Switch the DIP switch to the “Normal” position then power cycle the module. HRT-711 Modbus TCP to HART Gateway- QuickStart (Jan/2018) ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717...
Page 9
Step 13: When the Ethernet LED on the RJ-45 is on, click Search Servers to search all ICPDAS devices. Step 14: Double click HRT-711 in the list to assign network parameters. Then click OK to apply new setting when finish configuration.