Table of Contents
Advertisement
Switch Installation
Installing the Switch
Installing the Switch
This section describes how to install the switch:
Installing the Switch on a DIN Rail, page 19
Removing the Switch from a DIN Rail, page 20
Warning:
This equipment is supplied as "open type" equipment. It must be mounted within an enclosure that is
suitably designed for those specific environmental conditions that will be present and appropriately designed to
prevent personal injury resulting from accessibility to live parts. The interior of the enclosure must be accessible
only by the use of a tool.
The enclosure must meet IP 54 or NEMA type 4 minimum enclosure rating standards. Statement 1063
Warning:
When used in a Class I, Division 2, hazardous location, this equipment must be mounted in a suitable
enclosure with proper wiring method, for all power, input and output wiring, that complies with the governing
electrical codes and in accordance with the authority having jurisdiction over Class I, Division 2 installations.
Statement 1066
Caution:
To prevent the switch from overheating, ensure these minimum clearances:
– Top and bottom: 2.0 in. (50.8 mm)
– Exposed side: 1.0 in. (25.4 mm)
– Front: 2.0 in. (50.8 mm)
Installing the Switch on a DIN Rail
The switch ships with a spring-loaded latch on the rear panel for a mounting on a DIN rail.
To attach the switch to a DIN rail, follow these steps:
1.
Position the rear panel of the switch directly in front of the DIN rail, making sure that the DIN rail fits in the space
between the two hooks near the top of the switch and the spring-loaded latch near the bottom.
2.
Holding the bottom of the switch away from the DIN rail, place the two hooks on the back of the switch over the top
of the DIN rail.
Caution:
Do not stack any equipment on the switch.
19
Advertisement
Table of Contents
