Ricoh PRIPORT JP1210 Operating Instructions Manual page 103

SilverV-gb.book Page 83 Monday, May 15, 2000 3:32 PM
When one of the following messages is displayed on the guidance display
Guidance Display
RE-ENTER COPY NUMBER MAXIMUM
IS XXX
RE-ENTER COPY NUMBER MINIMUM
IS XXX
SET THE ORIGINALS
INPUT YOUR ID CODE
NO ADDITIONAL PRINTS ALLOWED Security mode is set. If you make the next mas-
MASTER MAKING HALTED
- When a service code (E-XX) is displayed in the guidance display -
- -
Turn the main switch off and on. If a service code appears again, contact your
service representative.
Note
If a service code appears on the guidance display after you turn the main
switch off and on a few times, do not continue turning it on and off. Leave the
machine off.
E04 might be displayed when you make masters continuously using the orig-
inals that have solid images. In the case, turn off the main switch and wait for
a while.
If Your Machine does not Operate as You Want
Meaning
The maximum number of prints that can be
entered is specified by the Service Program
mode. Change the number of prints.
The minimum number of prints that can be en-
tered is specified by the Service Program
mode. Change the number of prints.
Make prints after you confirm whether there is
an original.
User Code mode is set. Before printing, enter
your user code.
ter, Security mode is canceled.
Master making is halted.
Press the {Start} key.
5
83