Belling 600G Users Manual & Installation Handbook page 51

1. The inlet to the appliance is ISO 7 - Rp
right corner of the rear.
2. Fit the bayonet connection to the wall in the shaded area as shown.
The shaded area shown is applicable to installations in minimum depth cabinets.
If more room is available, the bayonet fixing area can be extended, provided that the
flexible tube does not obscure the fan intake.
3. Use a 900mm - 1125mm length of flexible connector. The flexible connector shall be
fitted such that it cannot come into contact with a moveable part of the housing unit
(eg; drawer) and does not pass through any space susceptible of becoming congested.
Make sure that the flexible connector does not block the cooling fan inlet.
4. Flexible connections should be to BS669. Parts of the appliance likely to come into con-
tact with a flexible connector have a temperature less than 70˚C.
5. Rigid connections must be accessible to disconnect for servicing. Cut a 150mm square
hole in the right hand rear corner of the support shelf for the supply pipe.
6. Make sure all connections are gas sound.
Important: - ensure that you route all mains and electrical cables and flexible tubing well
clear of any adjacent heat source.
Installing Your Cooker
Connect to gas supply
1
⁄2" internal thread situated towards the top
60 mm
Rear
Wall
48
60
mm
60 mm
square