Table of Contents
Advertisement
700, 720 & 900 models
Note: The unit housing the appliance must be appropriately fixed.
There are 6 securing screws.
•
Open the grill / top oven door, and screw 2 screws through the top corner holes in the
front frame.
•
With the grill / top oven door still open, screw 2 screws through the holes in the front
frame, located under the grill compartment.
Close the grill / top oven door.
•
Open the main oven door, and screw the remaining 2 screws through the bottom cor-
ner holes in the front frame.
Close the main oven door.
Notes: 700 & 720 models
Method 1: Care must be taken to ensure the appliance runners are sufficiently engaged over
the top of the runners on the base units. For installation Method 1 (700 & 720 models only) ,
you will need to drill through the fixing holes into the side trims with a 3.2mm diameter drill.
Method 2: Insert appliance into cabinet - ensure that it is engaged over the top of the side
runners.
Method 3: Insert appliance into cabinet.
Note: Ensure that the appliance is centrally located. Take care not to damage the appliance
or cabinet.
600 models
Insert appliance into cabinet. To secure the appliance to the housing unit, open the oven
door and screw 4 screws - 2 at top, 2 at bottom - through the holes in the front frame.
Installing a hob above the appliance (if applicable)
Where the appliance is installed under a worktop, with a hob installed above it, the instal-
lation instructions for the hob must be read in conjunction with these instructions.
When installing a gas hob above the appliance, care must be taken to ensure the hob inlet
pipe is as close to the back wall as possible, so it doesn't obstruct the appliance or the appli-
ance inlet pipe.
If a flexible inlet pipe is used, it must hang vertically and not be trapped between the oven
and rear wall.
Installing Your Cooker
To secure appliance to housing unit
51
Hide quick links:
Advertisement
Table of Contents
