Belling 600G Users Manual & Installation Handbook page 44

Before installing the appliance, check the internal dimensions as shown.
The space for the appliance must be clear of obstruction. You may have to cut into or
remove any rear cross members to obtain the 550mm minimum depth.
The fixing kit is available from the Sparees Sales Team, please call 0870 458 9961 and
order part number 01 28287 00.
The kit consists of 2 side trims (687mm long) and 4 runners (420mm long). The fixing
screws are in a polythene bag in the oven.
How to use your fixing kit:
1. Take the 6 No 8 x 12mm (silver) self tapping screws from the polythene bag, and use
them to fit one runner to each side of the appliance.
2. Make sure they are the right way up as shown.
3. Take one of the side trims, hold it against the side of the base unit, and mark off 687mm
from the top edge of the base unit, to the top edge of the runner.
Note: This ensures a 5 - 8mm clearance from the underside of the worktop to the top
of the appliance.
4. Measure 50mm from the front edge of the base units, to mark the front edge of the
runners.
5. Take 6 of the No 8 x 12mm (Black) chipboard screws and screw the runners into oppo-
sition the right way up as shown.
6. Fit the side trims to be flush to the top and front edges of the base units, using the
remaining 6 No 8 x 12mm (Black) chipboard screws.
Installing Your Cooker
700 & 720 installation Method 1:
Without housing unit (between 2 base units)
41