Table of Contents
Advertisement
Chapter 3. Diagnostics
This chapter describes the diagnostic tools that are available to help you solve
problems that might occur in the server.
If you cannot diagnose and correct a problem by using the information in this
chapter, see Appendix A, "Getting help and technical assistance," on page 325 for
more information.
Diagnostic tools
The following tools are available to help you diagnose and solve hardware-related
problems:
v POST error messages
v Event logs
v Troubleshooting tables
v Light path diagnostics
v Diagnostic programs, messages, and error codes
Event logs
Error codes and messages are displayed in the following types of event logs:
v POST event log: This log contains the three most recent error codes and
v System-event log: This log contains all IMM, POST, and system management
© Copyright IBM Corp. 2014
The power-on self-test (POST) generates messages to indicate successful test
completion or the detection of a problem. See "POST error codes" on page 26
for more information.
For information about the POST event log, the system-event log, the integrated
management module (IMM) event log, and the DSA log, see "Event logs" and
"System-event log" on page 37.
These tables list problem symptoms and actions to correct the problems. See
"Troubleshooting tables" on page 75.
Use the light path diagnostics to diagnose system errors quickly. See "Light path
diagnostics" on page 90 for more information.
The diagnostic programs are the primary method of testing the major
components of the server. See "Diagnostic programs, messages, and error
codes" on page 97 for more information.
messages that were generated during POST. You can view the POST event log
through the Setup utility.
interrupt (SMI) events. You can view the system-event log through the Setup
utility and through the Dynamic System Analysis (DSA) program (as the IPMI
event log).
The system-event log is limited in size. When it is full, new entries will not
overwrite existing entries; therefore, you must periodically save and then clear
the system-event log through the Setup utility when the IMM logs an event that
indicates that the log is more than 75% full. When you are troubleshooting, you
might have to save and then clear the system-event log to make the most recent
events available for analysis.
Messages are listed on the left side of the screen, and details about the selected
message are displayed on the right side of the screen. To move from one entry
to the next, use the Up Arrow (↑) and Down Arrow (↓) keys.
23
Advertisement
Table of Contents
