Removing A Simple-Swap Hard Disk Drive - IBM 7378 Problem Determination And Service Manual

Removing a simple-swap hard disk drive

Attention:
power from the server before removing or installing a simple-swap hard disk drive.
To remove a simple-swap hard disk drive, complete the following steps.
1. Read the safety information that begins on page vii and "Handling
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Unlock the left-side cover.
4. Open the bezel.
5. Grasp the tab on the drive bay EMC shield and rotate it to the open position.
194
IBM System x3400 M3 Types 7378 and 7379: Problem Determination and Service Guide
Simple-swap hard disk drives are not hot-swappable. Disconnect all
static-sensitive devices" on page 151.
and external cables.
Note: You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.