Features And Specifications - IBM 7378 Problem Determination And Service Manual

Features and specifications

The following information is a summary of the features and specifications of the
server. Depending on the server model, some features might not be available, or
some specifications might not apply.
Table 1. Features and specifications
Microprocessor:
v Intel Xeon up to six-core with
integrated memory controller and
Quick Path Interconnect (QPI)
architecture
v Designed for LGA 1366 socket
v Scalable up to twelve cores
v 32 KB instruction cache, 32 KB
data cache, and 4MB, 8 MB and
12MB cache that is shared among
the cores
v Support for up to two
microprocessors, second
microprocessor with pluggable
VRM
v Support for Intel Extended Memory
64 Technology (EM64T)
Note:
v Use the Setup utility to determine
the type and speed of the
microprocessors. For a list of
supported microprocessors, see
http://www.ibm.com/servers/
eserver/serverproven/compat/us/
v Do not install an Intel Xeon
series microprocessor and an
™
Xeon 5600 series microprocessor
in the same server.
.
Video controller:
v Matrox G200eV video on system
board
v Compatible with SVGA and VGA
Power supply:
v Standard: One 670 watt (100 - 240
V AC)
Note: On models with eight 3.5-inch
or sixteen 2.5-inch hard disk drives,
need to upgrade power supply to
920-watt.
Hot-swap fans:
v Three (maximum)
Memory:
v Sixteen DIMM connectors (eight
per microprocessor)
v Minimum: 1 GB
Note: If you install a
ServeRAID-M1015 SAS/SATA
adapter, make sure at least 2 GB
of memory is installed in the
server before you run DSA from a
bootable CD.
v Maximum: 128 GB
– 48 GB using unbuffered
DIMMs (UDIMMs)
– 128 GB using registered
DIMMs (RDIMMs)
v Type: Registered or unbuffered
ECC double-data-rate 3 (DDR3)
800, 1066, and 1333 MHz DIMMs
only
v RDIMMs sizes: 1 GB, 2 GB , 4
GB , and 8 GB single-rank or
dual-rank
v UDIMMs sizes: 1 GB, 2 GB, and
4 GB single-rank or dual-rank
v Chipkill supported
™
5500
Drives:
v SATA:
– DVD (standard)
– DVD/CD-RW (optional)
– Maximum of two devices can
be installed
v Diskette (optional): External USB
1.44 MB
v Supported hard disk drives:
– Serial Attached SCSI (SAS)
Expansion bays:
v Sixteen 2.5-inch HDD bays (three
optical DVD drive bays)
v Four 3.5-inch simple-swap SATA
drives
v Eight 3.5-inch HDD bays (one
UltraSlim DVD drive)
v Three half-high 5.25-inch bays (one
DVD drive installed)
Note:
– SAS expander card does not
support 3 GB RAID adapters.
– If the server is configured for
RAID operation using a
ServeRAID adapter, you might
have to reconfigure your disk
arrays after you install drives.
See the ServeRAID adapter
documentation for additional
information about RAID operation
and complete instructions for
using the ServeRAID adapter.
– Full-high devices such as an
optional tape drive will occupy
two half-high
5.25-inch bays.
PCI and PCI-X expansion slots:
v Six PCI expansion slots on the
system board:
– Four PCI Express x8 (2x8 link,
2x4 link)
– One PCI Express x16 (x8 link)
– One PCI 32-bit
v One or two expansion slots on the
PCI extender card:
– Optional - One PCI Express x8
(x4 link) on the PCI-Express
extender card
– Optional - Two PCI-X 64/133
slots on the PCI-X extender card
Chapter 2. Introduction
7