Table of Contents
Advertisement
Removing a 3.5-inch hot-swap hard disk drive
Attention:
than 10 minutes without either a drive or a filler panel installed in each drive bay.
To remove a 3.5-inch hot-swap SAS or hot-swap SATA hard disk drive, complete
the following steps.
1. Read the safety information that begins on page vii and "Handling
2. Unlock the left-side cover.
3. Open the bezel by pressing the button on the left edge of the bezel, and rotate
4. Rotate the drive tray handle of the drive assembly to the open position.
5. Grasp the handle of the drive and pull the drive out of the bay.
190
IBM System x3400 M3 Types 7378 and 7379: Problem Determination and Service Guide
To maintain proper system cooling, do not operate the server for more
static-sensitive devices" on page 151.
Note: You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.
the left side of the bezel away from the server.
Advertisement
Table of Contents
