Removing a 2.5-inch hot-swap hard disk drive
To remove a hot-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page vii and "Handling
2. Unlock the left-side cover.
3. Open the bezel by pressing the button on the left edge of the bezel, and rotate
186
IBM System x3400 M3 Types 7378 and 7379: Problem Determination and Service Guide
static-sensitive devices" on page 151.
Attention:
Static electricity that is released to internal server components
when the server is powered-on might cause the server to halt, which might
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
Note: You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.
the left side of the bezel away from the server.