Removing A Simple-Swap Hard Disk Drive - IBM System x3620 M3 7376 Installation And User Manual

Attention:
than 10 minutes without either a drive or a filler panel installed in each bay.
To install a drive in the simple-swap bay, complete the following steps:
1. Read the safety information that begins on page vii, "Installation guidelines" on
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the drive filler panel from one of the empty simple-swap bays.
4. Align the hard disk drive with the guide rails in the bay.
5. Pull the round blue loops of the hard disk drive toward each other; then,
Note: You might have to reconfigure the disk arrays after you install hard disk
drives. See the RAID documentation on the IBM ServeRAID Support CD for
information about RAID controllers.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 78.

Removing a simple-swap hard disk drive

Attention:
than 10 minutes without either a drive or a filler panel installed in each bay.
To remove a hard disk drive from a simple-swap bay, complete the following steps:
1. Read the safety information that begins on page vii, "Installation guidelines" on
2. Turn off the server and all attached devices; then, disconnect all power cords
To maintain proper system cooling, do not operate the server for more
page 28, and "Handling static-sensitive devices" on page 30.
external cables (see "Turning off the server" on page 18).
carefully slide the drive assembly into the drive bay until it stops, and release
the loops.
To maintain proper system cooling, do not operate the server for more
page 28, and "Handling static-sensitive devices" on page 30.
and external cables.
Chapter 2. Installing optional devices
53