Connection Procedure; Setting Terminal Parameters - NEC QX-S6648XP-6Q Installation Manual

Installation Guide
QX-S6600 Series Ethernet Switches
A side
Pos.9
Pos.1

4.2.2 Connection procedure

To connect a terminal (for example, a PC) to the switch:
Plug the DB-9 female connector of the console cable to the serial port of the PC.

Connect the RJ-45 connector to the console port of the switch.

 NOTE:
Identify the mark on the console port and make sure you are connecting to the correct port.

The serial ports on PCs do not support hot swapping. If the switch has been powered on, connect the

console cable to the PC before connecting to the switch, and when you disconnect the cable, first
disconnect from the switch.

Setting terminal parameters

To configure and manage the switch, you must run a terminal emulator program on the
console terminal.
The following are the required terminal settings:
Bits per second—9,600

Data bits—8

Parity—None

Stop bits—1

Flow control—None

Emulation—VT100

A
4 Accessing the switch for the first time
Console cable
Main label
4-2
B side
8
B
1