Table of Contents
Advertisement
Installation Guide
QX-S6600 Series Ethernet Switches
2)
Squeeze the tabs on the power cord connector with your thumb and forefinger, and
pull the connector out to remove the power cord, as shown in Figure 3-21.
3)
Hold the handle on the power module with one hand, pivot the latch on the power
module to the right with your thumb, and pull the power module part way out of the slot,
as shown in Figure 3-22.
4)
Supporting the power module bottom with one hand, slowly pull the power module out
with the other hand.
5)
Put away the removed power module in an antistatic bag for future use.
(1) Press the tabs on the power cord connector
with your thumb and forefinger
Removing the DC power cord
(2) Pull the power cord connector out
3-20
3 Installing the switch
Advertisement
Chapters
Table of Contents
