Using Tftp To Upgrade Software Images Through The Management Ethernet Port6-15 - NEC QX-S6648XP-6Q Installation Manual

Installation Guide
QX-S6600 Series Ethernet Switches
7. Skip
configuration
8. Set
recovery
9. Set switch startup mode
Reboot
0.
Ctrl+Z: Access
ASSISTANT MENU
Ctrl+F: Format file system
Ctrl+P: Change authentication for
console login
Ctrl+R: Download
SDRAM and run
6.5.3 Using TFTP to upgrade software images through the management
Ethernet port
1) Enter 1 in the Boot menu to access the file transfer protocol submenu.
1. Set TFTP protocol parameters
2. Set FTP protocol parameters
Item
Start the switch with the factory default configuration. This is a one-time
current system
operation and does not take effect at the next reboot. You use this option
when you forget the console login password.
Disable or enable the Boot ROM password recovery function. By default,
Boot ROM recovery is enabled. You can disable this function to protect
system security.
BootRom password
If Boot ROM recovery is enabled, you can contact the NEC support to get a
super Boot ROM password to access the Boot menu after your Boot ROM
password is lost.
If Boot ROM recovery is disabled, you cannot use a super Boot ROM
password to access the Boot menu after your Boot ROM password is lost,
and must contact your NEC agent for help.
Set the startup mode of the switch to normal (full) mode or fast mode.
Restart the switch.
EXTENDED
Access the EXTENDED ASSISTANT MENU.
Format file system
Change authentication for console login. You can use super commands
without entering the password.(this configuration is valid once)
Only when the password recovery capability is enable, this configuration is
effective.
A system software image is downloaded and the switch is started. Only
image to
when the password recovery capability is enable, this configuration is
effective.
Description
CAUTION:
6-15
6 Upgrading software