Installing/Removing A Power Module - NEC QX-S6648XP-6Q Installation Manual

Installation Guide
QX-S6600 Series Ethernet Switches
slot. Support the fan tray bottom with the other hand, and pull the fan tray slowly along
the guide rails out of the slot.
4) Put away the removed fan tray in an antistatic bag for future use.

Installing/removing a power module

WARNING:
In power redundancy mode, you can replace a power module without powering off the switch but must strictly
follow the installation and procedures in Figure 3-17 and Figure 3-18 to avoid any bodily injury or damage to the
switch.
QX-S6632QP come with the power module slots empty and filler panels for the power
module slots as accessories. QX-S6648XP-6Q and QX-S6648XT-6Q come with power
module slot 1 empty and a filler panel installed in power module slot 2.
For more information about the power modules available for the switches, see "Hot
swappable power modules".
Install the power
Switch off the circuit
module
breaker
Installation procedure
Connect the power
cord
Removal procedure
Disconnect the power
cord
3-17
3 Installing the switch
Switch on the circuit
breaker
Remove the power
module