Connecting The Rj45 Connector; Examining The Installation Site - NEC QX-S6648XP-6Q Installation Manual

Qx-s6600 series
Table of Contents

Advertisement

Installation Guide
QX-S6600 Series Ethernet Switches

Connecting the RJ45 connector

 NOTE:
When connecting the RJ45 cable, wear a wrist strap to protect against static electricity.
Do not touch the RJ45 Ethernet cable terminal. If you touch the RJ45 Ethernet cable
terminal which is connecting to the Switch, the interface circuit may be broken by the static
electricity. When you connect the Console cable, you need also a same care.

Examining the installation site

The QX-S6600 Series switches must be used indoors.
Mount your switch in a rack and make sure:
Adequate clearance is reserved at the air inlet and exhaust vents for ventilation.
The rack has a good ventilation system.
Identify the hot aisle and cold aisle at the installation site, and make sure ambient air
flows into the switch from the cold aisle and exhausts to the hot aisle.
Identify the airflow designs of neighboring devices, and prevent hot air flowing out of
the bottom device from entering the top device.
The rack is sturdy enough to support the switch and its accessories.
Connecting the RJ45 connector
2-2
2 Preparing for installation

Advertisement

Table of Contents
loading

This manual is also suitable for:

Qx-s6648xt-6qQx-s6632qp

Table of Contents