Section 5 Points For Caution - Renesas User System Interface Board HS1664ECH61H User Manual

1. Before connecting any parts or cables, make sure that the pins at the pin 1 position on both
sides are correctly aligned.
2. Do not apply excessive force to the user system interface board while it is connected to the
user system.
3. The dimensions of the recommended mounting pad for the IC socket for this user system
interface board are different from those of the pad for the MCU.
4. This user system interface board is specifically designed for the HS1650EPH60H emulator.
Do not use this board with any other emulator.
5. When power is not being supplied to the Vcc pin on the user system interface board, the
emulator displays ** VCC DOWN. In this situation, the emulator will not operate correctly.
6. The P1 short connector is used for testing. Do not remove the inserted jumper pin.
7. Do not connect this user system interface board to the user system for the H8SX/1650 group.

Section 5 Points for Caution

1 P1 3
USER ON
SW1
USER OFF
Figure 17 Jumper Socket
Do not remove the
jumper pin.
21