Section 6 Points For Caution - Renesas H8SX/1638 User Manual

1. Before connecting any parts or cables, make sure that the pins at the pin 1 position on both
sides are correctly aligned.
2. Do not apply excessive force to the user system interface board while it is connected to the
user system.
3. The dimensions of the recommended mounting pad for the IC socket for this user system
interface board are different from those of the pad for the MCU.
4. This user system interface board is specifically designed for the HS1650EPH60H emulator.
Do not use this board with any other emulator.
5. When power is not being supplied to the Vcc pin on the user system interface board, the
emulator displays ** VCC DOWN. In this situation, the emulator will not operate correctly.
6. The P1 and SW6 jumper sockets are for use in testing. Do not remove the inserted jumpers.
CS5-D
CS6-D
CS[4:7]-C
USER OFF
PF6
PF7
USER ON

Section 6 Points for Caution

Port J, K
SYNC
PF5
Port D, E
ASYNC
Figure 19 P1 and SW6 Jumper Sockets
Section 6 Points for Caution
Do not remove the jumpers.
Rev. 3.00 Sep. 08, 2008 Page 27 of 30
REJ10J1870-0300